EMTT AR-GEWe can help

VES and modelling

For details on how VES data should be collected and what to watch for, click here.

1D and modelling

Your field data are inverted and, using suitable points, two kinds of section are prepared:

  1. An Occam inversion produces a section using thin layers.
  2. A layered-earth approach produces a section with a few layers.
Occam inversion result
Layered model result
Layered model result

We need the coordinates of the sounding points and the spread directions. If you send VES data in the format below, a pseudo-2D section (and level maps) can be produced from suitable data. Contact us.

AB/2  MN(or MN/2)  Roa
2     0.25         10
3     0.25         10.3
…

2D and modelling

2D inversion result
2D inversion result

Your field data are inverted in 2D to prepare a section. We need the coordinates of the sounding points (or distances between them) and the spread directions:

VES1 X1 Y1 Z1
VES2 X2 Y2 Z2
…

Spreads may be oriented in the X (N-S), Y (E-W) or any other direction, but they must overlap (details). If topography along the profile is available, it is used in the inversion. Contact us.

3D modelling

To see how much information a field survey will provide, how it will be affected by surrounding geology and features (lake, sea, etc.), and to support survey planning, synthetic VES data are generated over a possible or expected model. Sections are then prepared by 1D or 2D inversion along selected lines. Contact us.

References